Skip to content

Free installation, and a quote in plain English: (512) 601-8389

Bee Cave · Lakeway · Steiner Ranch · Barton Creek

(512) 601-8389

ServicesIron and Sulfur Removal

Iron and Sulfur Removal in Bee Cave

Rust-colored stains and water that smells like rotten eggs both have a cause you can measure. We test your water, show you the numbers, explain what they mean and fit a system that removes iron and sulfur before it reaches your faucets.

Technician seen from behind working on a tall black filter tank with control head beside a rust-stained pipe and blue pressure tank against a garage block wall

What iron and sulfur removal actually does

Iron and hydrogen sulfide are two of the most common reasons people start looking at water treatment. Neither is usually a health threat. Iron is mostly a staining and taste problem, and the EPA sets its guideline for iron at 0.3 parts per million for exactly that reason. Hydrogen sulfide is the gas behind the rotten-egg smell, and you can notice it at very low levels.

An iron and sulfur system turns these dissolved minerals into particles a filter bed can catch, then flushes them out on a schedule. The water coming into your home looks and smells the same as it would from a clean source, and your fixtures, laundry and appliances stop collecting orange and black residue.

Before we suggest any equipment, we figure out which problem you have. Sometimes the smell comes only from the hot water heater, and that is a much smaller fix than a whole-house filter. We will tell you if that is the case.

What's included when we treat iron and sulfur

A water test first
We measure iron, manganese, hydrogen sulfide, pH and hardness. Each one changes which filter works, so we do not guess.
A plain answer on the cause
We walk you through your results line by line. You will know which of these you have: clear-water iron, red-water iron, iron bacteria, sulfur gas or a water heater reaction.
The right filter type for your numbers
Light iron and sulfur often suit an air-injection filter that oxidizes the minerals and traps them in the tank. Heavier levels may need catalytic carbon, a greensand-style media or a small feed system ahead of the filter. We explain why we picked one over another.
Installation at your main line
We place the system where the water enters your home, add a bypass valve so you can isolate it, and run the backwash drain properly. Installation is free.
Setup and a walkthrough
We program the backwash cycle for your water use and show you what normal operation looks and sounds like.

Signs iron or sulfur is in your water

  • Orange or brown stains

    Rings in toilets, streaks under faucets and rust tones on a white shower floor point to iron. Bleach usually makes these stains worse, not better.

  • A rotten-egg smell

    That smell is hydrogen sulfide. If you notice it on both hot and cold taps, the source is likely the water supply.

  • Smell only from hot water

    This often means the anode rod in your water heater is reacting with sulfate in the water. Swapping the rod may solve it, and we will say so.

  • Water that clears, then turns cloudy

    Clear-water iron is dissolved. It looks fine from the tap, then turns yellow or orange after sitting in a glass for a while.

  • Slimy reddish buildup

    A gel-like film in the toilet tank can mean iron bacteria. It needs a different approach than plain iron, which is why testing comes first.

  • Dingy laundry and odd tastes

    Whites that slowly turn yellow, and coffee or tea that tastes metallic, are both common with iron.

What affects the price of iron and sulfur removal

No two water samples are the same, so we price from your test results rather than a flat number. The amount of iron and sulfur, and the form they take, decide most of the cost. You get your quote by phone or after the test, with nothing hidden.

How much iron and sulfur

Low levels can be handled by a single air-injection tank. Higher levels may call for a larger tank or a feed system that adds an oxidizer before the filter.

Iron bacteria or manganese

Both need extra treatment steps. Manganese in particular can leave black stains and changes the media we choose.

Your home's water use

More bathrooms and people mean a higher flow rate, and the system has to be sized to keep up without dropping pressure.

Space and drain access

The filter needs a drain for its backwash cycle. A tight garage or a long run to a drain adds some labor.

Other equipment in the line

If you also want a softener or whole-home filtration, we plan the order of the systems so each one works as it should.

How an iron and sulfur job runs

  1. 1

    Free water test

    We collect a sample from your home and test it for the minerals and gases that matter here. You see every result, not just a recommendation.

  2. 2

    Your options, explained

    We lay out the system we think fits, plus any simpler fix if one exists. You get a written quote with the equipment and work listed.

  3. 3

    Install day

    Most installs take a few hours. Your water is off for part of that time, and we tell you before we shut it. We protect the floor where we work and clean up afterward.

  4. 4

    Flush and check

    We run the first backwash, flush the lines and check the treated water with you so you can see and smell the difference.

Technician kneeling at the main water line in a garage beside a softener, brine tank and filter housings while a homeowner watches

Iron and sulfur removal questions

Is iron or sulfur in my water dangerous?

At the levels usually found in homes, iron is mainly a staining and taste issue, and hydrogen sulfide is mostly a smell. Very high sulfur levels can be unpleasant to breathe in a closed shower, but that is uncommon. The test tells us exactly what you have, so you are not left guessing.

Can a water softener remove iron?

A softener can remove small amounts of dissolved iron, but iron fouls the resin over time and it does nothing for sulfur smell. If your test shows more than a trace of iron, a dedicated iron filter ahead of the softener is the better setup. Many Hill Country homes have hard water too, so we often plan both together.

How do I know if the smell is my water heater?

Run cold water from a bathroom sink, then hot water, and smell each. If only the hot side smells, the water heater anode rod is the likely cause. We will check this during your visit and tell you if a new rod is all you need.

How much upkeep does an iron filter need?

Most air-injection systems clean themselves with an automatic backwash, usually at night. Some media needs replacing after several years, and feed systems need their solution topped up. We explain the exact upkeep for the system we install before you decide.

What warranty comes with the equipment?

Our iron and sulfur systems carry a lifetime warranty on tanks and ceramic discs, 5 years on the control valve, circuit board and filter media, and 1 year on labor. Tanks and ceramic discs are covered for life, and the control valve, circuit board and filter media for 5 years. Labor is covered for 1 year.

Gray weatherproof softener enclosure on a concrete pad beside a brick house, with water line, brass valve and electrical box on the wall and a salt bag nearby

Find out what's staining your sinks

A quick test shows whether iron, sulfur or your water heater is behind the problem. We will explain the results, give you a quote and install the system free if you go ahead.